The Sewell PoE Injector can save you money by using an existing Ethernet line to deliver data and power.
The Sewell PoE Injector can easily connect any IEEE 802.3af-compliant device to a non-PoE LAN switch port. This PoE Injector can be used to connect a wireless access point, IP phone, network camera, or any IEEE 802.3af powered device to a LAN switch.
Reduce Wiring Costs
With the Sewell PoE Injector you can dramatically reduce wiring costs by powering devices through your existing Ethernet line rather than running new AC power lines. To use this product all you need to do is connect the Sewell PoE Injector to the LAN switch port, and then use your existing Ethernet Cable to deliver DC power and data to your device.
Protect Your Equipment
Now that you are running DC power to your networked equipment through the Cat5 cabling, you need to be sure that your devices are protected from power problems The Sewell PoE Injector is equipped with short circuit protection keeping your devices safe. This product is designed to protect your products from overloads over 450 mA and high voltages exceeding 52V.
Standard: IEEE802.3/3u 10BASE-T/100BASE-TX
IEEE802.3af Power over Ethernet
Network Cable: 10BASE-T: 2-pair UTP/STP Cat.3, 4,5 cable, EIA/TIA-568 100-ohm (100m)
100BASE-TX: 2-pair UTP/STP Cat.5 cable, EIA/TIA-568 100-ohm (100m)
Mix Ethernet and power into RJ45 port